Cannon VoIP Help

Find which switch port a desk phone is plugged into (troubleshooting mode)

Troubleshooting mode shows the phone's switch, port, port speed, IP address, firmware and MAC on its own keys. Built for IT teams.

Updated 1 week ago

Troubleshooting mode is for IT teams and installers. It answers "what is this phone plugged into?" without tracing cables: the phone shows its network details on its own screen, so you can read them standing at the desk.

Turn it on

Either way works:

  • From the phone: dial 77843. The phone says troubleshooting mode is on, and the keys change once you hang up.
  • From the portal: go to Phone System > Extensions & Phones, open the Phones tab, and press Troubleshoot next to the phone.

It works on the VoIP-6 and VoIP-12.

What the keys show

The bottom keys change for 30 minutes. On a phone plugged into a network cable:

  • The switch: who made it (worked out from the switch's own address), and the switch's name
  • The port on that switch the phone is plugged into
  • Port speed: the speed the phone's network port connected at, such as 100M or 1G
  • The phone's IP address on your network
  • Firmware: the version the phone is running (FW and a number)
  • The phone's MAC address, split over the last two keys

A phone on Wi-Fi shows Wi-Fi, the network's name and the signal strength instead of the switch and port.

The switch and port come from the switch itself (LLDP). When the switch doesn't share them, the key says Switch - rather than guessing.

While it's on

Calls keep working. Only the bottom keys change: the line, the person's name and every other key stay as they are.

Turn it off

It turns itself off after 30 minutes. To end it sooner, dial 77843 again, or press the button in the portal again (it reads Troubleshooting until and a time).

Was this helpful?
← All help articles