Cannon VoIP Help
Help › Fax

Keep your fax machine with a VoIP-ATA-1

Plug the machine into the adapter, add it on the Phones page, and set the machine itself so faxes go through first time.

Updated October 18, 2026

A fax machine you already own keeps working on the phone system through a VoIP-ATA-1 adapter. The machine answers one of your fax numbers and sends from it, and a copy of every fax can still land in the portal and your email.

Setting up the adapter

  1. On the Phones page, press Add, pick Fax machine on an adapter.
  2. Choose the fax number the machine answers and sends from (get one on the Numbers page first, or set a number there to Receive faxes).
  3. Choose what happens when a fax arrives: Ring the fax machine, Send to email and the portal, or Both (print on the machine and keep a copy).
  4. Type the MAC address printed on the sticker under the adapter, then save.
  5. Plug the adapter's Internet port into your router or switch and the fax machine's phone cord into its Phone port, then power it on. It sets itself up within a few minutes.
  6. Send yourself a test fax.

Settings on the fax machine itself

These are the settings on the machine, usually under its Fax or Line menu, that make faxing over the internet reliable. The names differ a little by maker.

  • Distinctive ring: off (No). The adapter rings the machine with a plain ring.
  • Auto answer: on, after 1 or 2 rings.
  • Fax speed (baud or transmit speed): Medium or Slow, often shown as 9600 or 14400. Fastest (33600) fails more often over the internet and gains almost nothing on a page.
  • Error correction (ECM): on.
  • Dial mode: tone, not pulse.
  • Dial prefix: none. Dial the number as you would from a phone, with the area code.
  • Line type: a regular phone line (PSTN), not PBX, if the machine asks.

When a fax will not go through

Retry once. If it fails the same way twice, lower the speed one step and make sure ECM is on. The Fax page lists every fax with its outcome in words, which tells you whether your side or the far machine gave up. Very old machines at the far end are the usual cause.

Was this helpful?
← All help articles