Cannon VoIP Help

Set an IP trunk's direction and failover

Choose inbound, outbound or both, how long to ring, and where calls go if the PBX can't answer.

Updated 1 week ago

  1. In the portal, open IP Trunks and find the trunk.
  2. Under Calls, set Directions: Inbound and outbound, Inbound only (your numbers ring the PBX) or Outbound only (the PBX dials out).
  3. Set Ring the PBX for (5 to 120 seconds). After that the failover takes the call.
  4. Under If the PBX can't answer, pick Company voicemail, Forward to a number (type it), or an extension.

The failover is used when the PBX isn't registered, is switched off, is full, or doesn't answer in time. A cell phone here keeps calls coming during an outage at the office.

911 always goes out, whatever the direction says.

Was this helpful?
← All help articles