Cannon VoIP Help

IP trunks: connecting your own PBX

Bring your own phone system; its calls ride our carrier rails with the same guardrails.

Updated September 16, 2026

An IP trunk is for a customer who already owns a PBX and wants it connected to real phone numbers through this platform. Your PBX does the ringing; the trunk carries the calls.

The IP Trunks page appears when the trunking module is enabled for your account; ask your dealer if you do not see it.

Create the trunk

  1. On IP Trunks, create a trunk and name it after the system it connects ("Warehouse 3CX").
  2. Pick how your PBX authenticates:
  3. - Registration: your PBX registers with a SIP username and password. The password is shown ONCE when created (and can be rotated later); put it straight into your PBX. - IP authentication: no registration; list the source IP addresses your PBX sends from.

  4. The page shows the SIP host your PBX should point at.

Point numbers at it

On the Numbers page, set each number's destination to Hand to your PBX (IP trunk) and pick the trunk. Inbound calls to those numbers are delivered to your PBX; set the inbound host if delivery should go somewhere specific.

The guardrails you inherit

Outbound calls through the trunk carry your caller-ID rules (you can only send numbers you own), SHAKEN signing, the international calling gate, and a channel cap you can see and raise. These are features: they keep a compromised PBX from becoming a toll-fraud bill.

Texting over the trunk

A trunk can also carry messaging: enable it, set your webhook URL, and inbound texts to trunk numbers POST to your system, signed, with the same signature scheme as platform webhooks.

Was this helpful?
← All help articles